2: Two pieces of wire with 0.10 inch exposed separated by 1.00 inches. 2: Two pieces of wire with 0.20 inch exposed separated by 0.200 inches. 1: Two pieces of wire with 0.10 inch exposed separated by 0.200 inches. All leads were fresh tin plated 22 Ga (0.0253 inch dia.) copper wire as follows:Ĭontact set No. I attached 6 wire leads to the perf-board. I prepared a test substrate made of some thin fiberglass 0.100 center perf-board. It was obvious that the dissolved solids had settled in the container, but they quickly re-dispersed and the material became a uniform, "thick liquid" or "thin paste". The material is manufactured by the Anders Products Division of Idolon Tech., Inc in Mass.Īfter opening the jar I mixed the material for a few minutes as the instructions dictate, with a toothpick. They sell the little jars for $3.99 each. The Wire Glue was purchased from ThinkGeek in Fairfax VA. I purchased some of the "Wire Glue" and decided to test its conductivity. WIRE GLUE TEST - Conductivity Measurements
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |